Important point: I found that if you run the query in RSRT "Execute + Debug" button and do not use the option "Do not use SAP HANA / BWA Index (0)" the query runs without problems.
Additional Information:
- BW on Hana environment 740 is a new installation.
- To load the historical data for the BW on Hana was created an RFC with the BW 701, classic BW as source system to new BW HANA.
- BW 701 was generated Export Data Sources ( From cube to cube, from DSO to DSO) and we used of data sources to migrate historical data.
- Then BW on Hana is a new installation, but only the historical data were extracted from the BW 701 (no Hana)
- Export Data source generated on DSO data is ok, but the Data source of export from a cube, data is not ok. After data load this historical data, when I make a query in Query Designer and I use between in "Filters and Restrictions" no returned values, but if I include the value and not use the between the values are displayed, but the problem occurs only in the query on the Cube.
- Are there any recommended when historical data is extracted on the Cube by Export Data Source?